Tacx Flux - 130mm dropouts

General discussion about the ANT+ Trainers

Moderators: mcorn, Tacx Moderator, malfukt, Nasz

Post Reply
andymatthews
Posts: 1
Joined: Tue Jan 15, 2019 11:58 pm

Tacx Flux - 130mm dropouts

Post by andymatthews » Wed Jan 16, 2019 12:17 am

Hi, struggling to get a sensible answer from either the Tacx Twitter support or the email support for my issue with second hand Tacx Flux. Hoping that someone can help here. The Tacx Flux I have has been set up for a bolt through and doesn't have the original QR type 130mm hub fittings which I can see online as the default set up. I've sent photos but am being told I don't need anything for my bike to fit - they're not reading the email correctly.

Trying to locate the dropouts on the Flux is not possible. They unscrew and looks like I need a different fitting to screw in to make it work as image. I can't find that part essentially and want to know if it's even available? Would be very grateful if anyone is able to help and tell me if it's even possible to buy these parts.

My setup...
Image
Image
Image

And what I need it to look like...
Image
Image

Any help gratefully received.

Post Reply

Return to “Tacx Bushido/Vortex/Genius/Neo”

Who is online

Users browsing this forum: No registered users and 8 guests