Firmware Update

General discussion about the ANT+ Trainers

Moderators: mcorn, Tacx Moderator, malfukt, Nasz

Post Reply
Energyendurance
Posts: 2
Joined: Thu Feb 08, 2018 2:06 am

Firmware Update

Post by Energyendurance » Thu Feb 08, 2018 2:11 am

I’m running a studio with 6 genius smart trainers. I downloaded the latest firmware update and now as I pick up the cadence and get into heavier gears the wheel will start spinning at such a high speed that there is no longer a feeling of resistance even on the heaviest gear possible. Is it possible to reverse the firmware to when my trainers were working perfectly?

User avatar
Alex Masalovich
Moderator
Posts: 1636
Joined: Sun Nov 30, 2014 10:17 pm
Contact:

Re: Firmware Update

Post by Alex Masalovich » Thu Feb 08, 2018 7:19 pm

Use this useful utility:
http://tacxdata.com/files/support/Geniu ... r_v102.exe
Before you run the utility place the trainer as close as possible to the ANT+ antenna and make sure that the tyre is not attached to the brake’s roller. After the procedure is completed, turn off the resistance unit for 2 minutes.
Тренируйтесь много, отдыхайте ещё больше!

Post Reply

Return to “Tacx Bushido/Vortex/Genius/Neo”

Who is online

Users browsing this forum: ms6073 and 12 guests