General discussion about the ANT+ Trainers
3 posts • Page 1 of 1
Hey folks - I've exhausted myself trying to research on both the Zwift and Tacx forums and hoping someone here may be able to offer a little assistance. Essentially just got my new Tacx Vortex Smart Trainer for Christmas. I've set everything up, and updated the firmware. However, when I go to calibrate on the Tacx Utility app, it never gets past the "Start Cycling" prompt. For whatever reason, the app also stays on 0.0km/h on the device connection. The wheel is properly inflated and is getting good resistance on they trainer. Is there something I am missing, or this just a defective trainer? Appreciate any assistance!
Who is online
Users browsing this forum: No registered users and 17 guests