Help with assembling bike onto Genius

General discussion about the ANT+ Trainers

Moderators: mcorn, Tacx Moderator, malfukt, Nasz

Post Reply
matede
Posts: 3
Joined: Tue Nov 21, 2017 1:46 am

Help with assembling bike onto Genius

Post by matede » Tue Nov 21, 2017 1:49 am

I've been having difficulties setting the trainer up. I am using it with a Trek Domane 4.3 bike and a 148x12mm axle. I purchased the T1708 axle skewer which fits well without any of the additional black bands. However when I go to install the wheel on the trainer, I cannot lock it at all. There is so much resistance. When I watch the instruction video, it seems as the wheel of that person easily goes in and there is enough space to lock the trainer on the axle. However, I struggled to even fit the axle through without a bit of pulling back. It has now gone in but when I go to lock it, it seems as though all it is doing when it reaches the resistance point (somewhere halfway) is widening the two trainer arms more. Can anyone help please?

Post Reply

Return to “Tacx Bushido/Vortex/Genius/Neo”

Who is online

Users browsing this forum: No registered users and 23 guests